Thread: DM 8000 Firmware Update through the browser

DM 8000 Firmware Update through the browser

What you need to update the firmware:

You need a current picture. That image has the extension *. dm8000 NFI.
Unable to play another type of image as *. IMG!
Please do not try it does not work.
Now * you need a DHCP server on your network, or a boot loader:
A null moden cable and a terminal program such as HyperTerminal.
You need a browser and a network cable.
Connect your Dreambox directly with a
PC, you need a "cross-over" (rotated), network cable to connect the box via a
Switch / hub / router you need a "no-Cross" (not twisted) cable network.
To import a new image to the Dreambox, you must have the "2nd phase" Loader
in place and in good condition.
The following steps refer to a network with a DHCP server.
If this is not the case, you must set manually via a serial cable, an IP address.







Turn off the dreambox, use this menu item "now"
after stop / standby menu (Deep-Standby mode) or disconnecting the box
Switch on the back of the box. Standby is not enough!
This image has been resized. Click this bar to view the full image. The original image is sized 700x291.







(1.) Press the bottom button on the front panel and hold.
(2.) Turn on the Dreambox, either with the switch on the rear of the dwelling, or
If you are in deep sleep mode, pressing the power button on the
Front Panel. Keep the bottom tste pressed.
(3.) It should display the text "*** *** STOP" on the screen. Appears something like "/ flash" ..
the screen, you do not have the right button.
Now you can let the button below.
The boot loader is in sleep mode.
(4.) Above the "*** STOP ***" text should now display the IP address displayed.
(four decimals separated) by one point. Will there still "DHCP" instead of a
IP address appears, the table still looking for a DHCP server. Wait briefly.
If, however, appear after a short time, have no IP address, see
Ask your DHCP server configuration and network cabling.
If the problem persists, please make a serial console, the IP
His picture manually.






- Now, open a browser on the PC.
(1.) Enter the IP address in the browser's address field "http://ip/ field.
(type the IP address screen is displayed on the box).
- (2.) Now press the select button "firmware" page shown in
Navigator.







- On the next page, you can now select the desired image
dubbing in the table as. Note the file extension *. NFI that
dub
other images not possible (NO *. img)!
- Click on the selection of images in the selection of "FLASH!" and wait
completely transferred to the image was brightened.
- Get the big picture, and then ask then again.
The Roadmap must now be registered and boot.

Translation PDF that I attached

http://www.ysharing.com/es/file/187/...owser-pdf.html